It is possible to tile many different materials and textures, however the preparation of walls is crucial. Before you start be sure to set the bathroom, kitchen or hallway walls. If you do not, some problems may arise. Also, make sure that the areas you're planning to tile clear of dust, water and grease. The adhesive will adhere properly and last long in the time (if you use the right product).

Here are some minor steps to take prior to tile

• Check for evidence of wall hangings, like nails, screws, or any other type of fitting;
• Eliminate the loose plaster.
• Remove and tear down wallpapers that are old;
• Be on the lookout for evidence of damage and cracks.
• Fill larger cracks via layering;
• Sand the wall to bring it, if necessary;
• Remove heavy and dirty particles;
• Cleanse and vacuum the walls;
• Prepare the surface prior to tile.

Begin by planning your wall-tile installation.

• Take a precise measurement of the surface.
• Calculate how many tiles you'll require.
• Also add another 10% to make sure you are covered if some break.

How do you level the wall?

The easiest method is to take a length of timber that is flat and use it to test on the walls for bumps. Move it along and alter your viewpoint while doing it. Bump that aren't more than 4 or 5 millimeters are fine. Anything greater than that would require extra caution. If the wall isn't well-leveled, the glue could loose its grip. If the adhesion layer is not thick enough, you could be unable to support tile weight, regardless the surface you use it on cement board, concrete or plywood.

It is recommended to make use of the correct kind of tile backerboard such as cement or fiber cement, glass mat gypsum, or water-resistant wallboard. The tile backers are water-resistant and therefore the best option for bathrooms with sinks close to the showers, and wet areas. The best choice for bathrooms is marine tile backers made from plywood.